Manual and Installation Guide

Series GA201M2 Page 17 Sept 25, 2020
Installation Instructions
Secure the Heater
1. Ensure that the Hold Down Brackets are properly installed as described in Installation Step 8.
2. The type of Foundation Fastener required depends on the type of Floor / Ground that the Heater is
located on. Prepare the Floor / Ground as detailed in Table A at all three bracket locations. (Ensure
that alignment with the connecting hole(s) of the Base Bracket is maintained.)
Table A: Methods for Securing Heater to Floor / Ground
Floor / Ground
Type
Foundation Fastener
Type & Size
Mounting Method Summary
Floor / Ground
Preparation
Concrete
Concrete Anchor
Ø5/16" x 2 1/2"
Place Anchors into pilot holes
aligned with Base Brackets -
tap / hammer lightly, screw
fastener into anchor
Drill 3 - Pilot Holes
Pilot hole drill size:
Concrete = 9/16"
Wood Deck
Wood Screw
#10 x 1 1/2"
Secure using Wood Screws in
pilot holes aligned with Base
Brackets
Drill 3 - Pilot Holes
Pilot hole drill size:
Hardwood = 7/64"
Softwood = 3/32"