User's Manual
Table Of Contents
- To Customers
- Contents
- 1.Safety
- 2. General Description
- 3. Installation
- 4.Software Setup
- 5. Operation
- 6. Regulatory Information
- 7. Trouble Shooting
- 8. Service Information
- Appendix
- FCC Regulations:
4. Software Setup
iRay Technology Co. Ltd. 45
4.5.1 Get Start with Default AP setting
The Mars1717V detector
alows user to get start
with Default AP setting
User could config the
panel with default setting
as follows
Set the Panel to AP
mode, as the 3.1.5 Mode
key discription
Setup the Workstation IP
address
Open local network
management interface
Right click the wireless
adapter, select
properties and entered
the Wireless Connetion
Properties window as
shown left.
Double click IPV4 item