User's Manual

SKR 40 0 0 DIRECT DIGITIZER User Manual
12
..................................................................................................................................................KONICA
MINOLTA, INC.
Otherwise, it may result in fire or electric shock.
 Clean the plug of the power cord periodically by
unplugging it from the A C outlet and removing dust or
dirt from the plug, its periphery and AC outlet with a
dry cloth.
If the cord is kept plugged in for a long time in a dusty,
humid or sooty place, dust around the plug will attract
moisture; this could cause insulation failure that may result
in a fire.
 For safety reasons, be sure t o turn off the power when
performing inspections indicated in this manual.
Otherwise, electric shocks may occur.
CAUTION
Installation and
environment of
use
 Do not install the product in any of the locations listed
below. Doing so may result in failure, malfunction,
falling, fire or injury.
Close to facilities where water is used
Where it will be exposed to direct sunlight
Close to the air outlet of an air-conditioner or ventilation
equipment
Close to heat source such as a heater
Where the power supply is unstable
In a dusty environment
In a saline or sulfurous environment
Where temperature or humidity is high
Where there is freezing or condensation
In areas prone to vibration
On an incline or in an unstable area
 Take care that cables do not become tangled during
use. Also, be careful not to get you r feet caught by
cable.
Otherwise, it may cause a malfunction of the product or
injury of the user due to tripping over the cable.
 Non-medical equipment such as b attery charger, access
point and infrared register tools cannot be used in
patient’s vicinity.