User's Manual

SKR 40 0 0 DIRECT DIGITIZER User Manual
48
..................................................................................................................................................KONICA
MINOLTA, INC.
4. Operation
SKR 4000 provides SDK for user to integrate panel into their DR system. Additionally, it also provides
an application for demonstration, i.e. iDetector. User can use iDetector to control panel without DR
system.
4.1. Main Operation
To Acquire X ray image is the main operation of SKR 4000. Most importantly, panel should build
synchronization with X ray generator. SKR 4000 is born with four ways to acquire x ray image, which
is Software Mode, Inner2 Mode, and FreeSync Mode.
4.1.1. Software Mode
4.1.1.1. Block Diagram
Software mode is the basic way to acquire x ray image. Please see figure below for general feature.
Works tation（Inner2） HV G
Tube
Workstation is a host device installed with iDetector and SDK. Chapter 3 has described how to establish
connection between panels and workstation. In software mode, workstation does not control x ray
generator. Users would decide when to shoot x ray.