User's Manual

Operation
KONICA MINOLTA,
INC..………….……………………………………………………………………………………………………
….…………….………..
65
Click “Read Status”
If the activity shows disenable,
please select the one and click
“Active” to enable it
4.7.2. Correction and Calibration management
Panel supports two ways to do correction and calibration. Software Correction and Calibration defines
the scenario that Workstation completes all correction and calibration. If panel complete all correction
and calibration by itself, it is named as Hardware Correction and Calibration.
User can set the calibration
method on “Detector” page