User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Safety and Regulatory Information
AJ4310 | 2019-08-13 1–5
Cautions
Environment for Installation and Use
Environment for Installa-
tion and Use
WARNING:
Do not use or store the product near flammable chemicals such as alcohol,
thinner, benzene, etc.
Chemicals that are spilled or evaporated may result in fire or electric shock
through contact with electric parts inside the product. Also, some disinfec-
tants are flammable. Be sure to take care when using them.
WARNING:
Do not connect the equipment with anything other than the specified
connectors to avoid fire or electric shock.
WARNING:
Keep all patients with active implantable medical devices away from the
product.