User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Safety and Regulatory Information
1–6 AJ4310 | 2019-08-13
Installation and Environ-
ment of Use
CAUTION:
Do not install the product in any of the locations listed below to avoid failure,
malfunction, falling, fire, or injury.
• Close to facilities where water is used
• Where there is exposure to direct sunlight
• Close to the air outlet of an air conditioner or ventilation equipment
• Close to a heat source such as a heater
• Where the power supply is unstable
• In a dusty environment
• In a saline or sulfurous environment
• Where temperature or humidity is high
• Where there is freezing or condensation
• In areas prone to vibration
• On an incline or in an unstable area
Installation and Environ-
ment of Use
CAUTION:
Do not allow cables to become tangled to avoid a malfunction of the
product.
Do not get your feet caught by a cable to avoid tripping and injury.
CAUTION:
Non-medical equipment such as battery chargers and access point and
infrared register tools cannot be used in the vicinity of a patient.