User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Safety and Regulatory Information
AJ4310 | 2019-08-13 1–9
Power Supply
WARNING:
Securely insert the power cord into the AC outlet to avoid a contact failure.
If a contact failure occurs or if metal objects come in contact with the exposed
metal prongs of the plug, fire or electric shock may result.
WARNING:
Be sure to turn off the power before connecting or disconnecting the cords to
avoid an electric shock that could result in death or serious injury.
WARNING:
Be sure to hold the plug or connector to disconnect the cord.
If you pull the cord, the core wire may be damaged, resulting in fire or electric
shock.
Power Supply
CAUTION:
• Always connect a three-core power cord plug to a grounded AC power
outlet.
• Keep the outlet free of obstacles for easy access to disconnect the plug at
any time and in an emergency.
• Be sure to ground the product to an indoor grounded connector. Be sure
to connect all the grounds of the system to common ground.
CAUTION:
Do not use any power source other than the one provided with the product
to prevent leakage that could result in fire or electric shock.