User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Safety and Regulatory Information
AJ4310 | 2019-08-13 1–11
Handling
CAUTION:
Do not spill liquid or chemicals onto the equipment. Do not allow an injured
patient’s blood or body fluids contact with the equipment.
Doing so may result in fire or electric shock.
In such a situation, protect the equipment with a disposable cover as neces-
sary.
CAUTION:
For safety Turn OFF the power and remove the plug for all equipment when
not used.
CAUTION:
Handle the product carefully.
Do not submerge the product in water.
Handling
CAUTION:
The internal image sensor may be damaged if struck or dropped. If the product
is dropped, the drop sensor inside would record and the product would not
be under warranty.