User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Safety and Regulatory Information
AJ4310 | 2019-08-13 1–15
Maintenance and Inspection
Maintenance and Inspec-
tion
WARNING:
• Turn off the power of the product and disconnect the power cord of the
adapter before cleaning.
• Never use alcohol, ether, and other flammable cleaning agent for safety.
Never use methanol, benzene, and acid to avoid corrosion on the equip-
ment.
• Do not place the product in liquid.
WARNING:
Make sure that the surface and connectors are dry before turning on the
product to avoid fire or electric shock.
WARNING:
Clean the power cord connector periodically. Disconnect the connector from
the AC outlet. Use a dry cloth to remove dust or dirt from the connector, its
periphery, and the AC outlet.
If the cord is kept plugged in for a long time in a dusty, humid, or sooty place,
dust around the plug will attract moisture; this could cause insulation failure
that may result in a fire.
WARNING:
For safety reasons, be sure to turn off the power when performing the inspec-
tions indicated in this manual to avoid electrical shock.