User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Overview
AJ4310 | 2019-08-13 2–5
Two or more batteries charging cannot be charged at the same time. Charging will
automatically stop if more than one battery is inserted.
X Indicator Operating Status
All off
No power input
A indicator on
• AC power input
• Multiple batteries inserted
A indicator on
B and C alternately blink 2 times
Battery insertion self test
A and B indicator on
Battery charging
A and C indicator on
Battery capacity full, charging
stops
A indicator on
B and C alternately blinking
Battery is not charging properly