User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Overview
2–10 AJ4310 | 2019-08-13
Mechanical Outlines
Use Environment
Tempe r ature
Temperature
Change Humidity
Atmospheric
Pressure Pressure Change
Operating 5–35 °C
(41–95 °F)
< 1k/min 10 %–90 %
RH
700–1060 hPa <10 kp/min
(1 kp=1.0197E-5Pa)
Storage -20–55 °C
(-4–131 °F)
< 1k/min 5 %–95 % RH 700–1060 hPa <10 kp/min
(1 kp=1.0197E-5Pa)
TRIMAX 35C detectors shall operate at a specified altitude of not more than 3000.0 m (9842.5 ft). The
environment specific is only for the detector.