User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Overview
AJ4310 | 2019-08-13 2–11
IT Network
Purpose for IT-network
Transmission of image data and command/status communication between the detector
and the workstation.
Required Features
Wireless communication follows IEEE 802.11a/b/g/n/ac protocol. It works on 2.4 GHz and
5 GHz.
It supports at least 2 routers.
Hazardous Situations from Failure of the IT Network
• Incompatibility of the operating system is not compatible
• Inability to update or change software
• Incompatibility of the interface
• Inconsistency of interface or format leads to data distortion
• Data transfer protocol error
• Data output failure
Required Configuration
The wireless card and the detector must work on the same IP segment such as
192.168.8.XXX.
They must support IEEE 802.11a/b/g/n/ac.
Technical Specifications
Item Specifications
Wireless Standard IEEE 802.11a/b/g/n/ac
Frequency Range 2.412-2.472 GHz: ch1-ch13
5.18-5.22 GHz: ch36-ch48
5.745-5.85 GHz: ch149-ch165