User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Installation
3–2 AJ4310 | 2019-08-13
2. Slide the battery into the battery compartment.
Note:
Make sure the battery level is >10 % of full capacity.
3. Slide the two battery lock levers toward the center of the detector..
Power on the Detector
On the control panel, the power button is used to power the detector on and off.
To power on the detector, press and hold the power button for 4 seconds. The detector
must either have a battery installed with >10 % charge or have the DC power connected.
To power off the detector, press and hold the power button for 4 seconds.