User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Installation
AJ4310 | 2019-08-13 3–3
To reset the detector, press and hold the power button for 8 seconds.
Power Indicator
After booting up, the user can check the status LED indicator.
Power Indicator Lighting Status
Operating Status
Operating Battery Capcity DC Input
OFF Power OFF -- --
Orange ON Power ON ≤20% No
Green ON Power ON
• Battery capacity ≥20 %, no DC
input
• DC input, no battery
Orange Blinking Power OFF <20 % Yes
Green and Orange
Blinking
Power OFF ≥20 % and <95 % Yes