User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Installation
3–4 AJ4310 | 2019-08-13
Link Indicator
Green Fast Blinking Power OFF ≥95 % and <100 % Yes
OFF Power OFF =100 % Yes
Power Indicator Lighting Status
Operating Status
Operating Battery Capcity DC Input
Power Indicator Lighting Status Description
Off
• Shut down
• Wired connection broken and wireless connection
not ready
Green On
Wired connection is built
Blue On
• Client mode, wireless connection is built
• AP mode, wireless AP is ready
Blue Blinking
Client mode, no connection is built
Green and Blue Blink-
ing
Client mode, no connection is built