User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Appendix
A–10 AJ4310 | 2019-08-13
3. Panel starts uploading a Pre-dark image and a Light image to the workstation for
preview. If hardware offset is selected, panel first performs an offset and then
uploads the preview image.
4. Panel starts uploading Post-dark image to the workstation. If hardware offset is
selected, panel first performs correction and calibration and then uploads the
processed image to the workstation.
5. Workstation enters exposure prohibit state.
Time Setting
To set a clear scenario for program, see the diagram below.
Freesync Mode
Block Diagram
The workstation is a host PC device installed with iDetector and SDK. Installation
describes how to establish connections between the panel and workstation. In FreeSync
mode, the user does not interact with the workstation. After taking x-rays, images
immediately appear on the screen.
Work Flow
1. X-ray generator is ready to take x-rays and starts releasing the x-ray.
2. Workstation receives Exposure Prohibited from the panel.
3. Panel starts uploading a Pre-dark image and a Light image to the workstation for
preview. If hardware offset is selected, panel first performs an offset and then
uploads the preview image.