User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Appendix
AJ4310 | 2019-08-13 A–15
7. Open the browser and type 192.168.1.1 and log into external wireless AP.
8. Do the wireless setup.
9. Configure 2.4 GHz wireless network.
• SSID: NETGEAR_BIG_24
• Security: WPA2-PSK
• Password: 12345678
• Channel: Check the current Wi-Fi environment, and choose a relatively clean
channel.
10. Configure 5G Hz wireless network.
• SSID: NETGEAR_BIG_50
• Security: WPA2-PSK
• Password: 12345678
• Channel: Check the current Wi-Fi environment, and choose a relatively clean
channel.