User's Manual
Table Of Contents
- 1 Notices and Conventions
- Contents
- 1 Notices and Conventions
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings A-1
- Operating Modes A-8
- Software Installation A-12
- Set the Connection Mode A-13
- Shortcuts A-24
- Establish a Connection with the Detector A-25
- Configure the Detector A-26
- Correction and Calibration Template Generation A-29
- Image Check and Upload A-35
- Defect Template Check and Modification A-37
- Correction and Calibration Management A-40
- Update the Firmware A-44
- Publication History
- 1 Safety and Regulatory Information
- 2 Overview
- 3 Installation
- 4 Operation
- A Appendix
- Software and Settings
- Operating Modes
- Software Installation
- Set the Connection Mode
- Shortcuts
- Establish a Connection with the Detector
- Configure the Detector
- Correction and Calibration Template Generation
- Image Check and Upload
- Defect Template Check and Modification
- Correction and Calibration Management
- Update the Firmware
- Publication History
Appendix
AJ4310 | 2019-08-13 A–25
Establish a Connection with the Detector
1. Open SDK, select the detector, and select Connect.
2. Confirm that the values for IP address and Port are the same as the values in
config.ini.
Note:
The value for Cfg_HostPort should be the default of 28000.
Note:
When the connection is changed to a different network card, the user must reconnect the
detector using a different IP address.
The rule of Multi-Share control is based on the IP address. The second terminal with a different
IP address is not allowed to operate a detector after the first one is connected. If there is no
command transmission between the detector and workstation after 5 minutes, the detector
releases access authority.