Owner`s manual

FM MODE
Tune in FM Mode
1. Press SOURCE to switch your radio from DAB mode to FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz).
Otherwise, the last listened FM station should be selected.
3. To manually change FM frequency, while frequency is showing up, press  or

to
change it 0.05MHz per step.
4. To automatically scan FM available stations, while frequency is showing up, simply press
SELECT.
The unit will display the frequency changing until it stops at the next station.
Scan setting
 By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations.
 To change the scan settings to stop only at stations with good signal strength, 2 steps:
1. Press MENU, and then press

to ‘Scan Setting’, press SELECT to confirm.

2. Press  or

to ‘Strong stations only’, press SELECT to confirm.
Audio Settings
 By default, all stereo stations are reproduced in stereo. For weak stations, this may result
in a poor signal-to-noise ratio (hiss).
 To play weak stations in mono, 2 steps:
1. Press MENU, press  or

to ‘Audio setting’, press SELECT to confirm.

2. Press  or

to ‘Forced mono’, press SELECT to confirm.