Owner`s manual

Set Alarm
 Note: Setting Alarm, make sure Clock time is set at first.
1. It can be activated from ‘System’ ‘Alarms’, press SELECT to confirm.
2. Press  or

to your target alarm: ‘alarm 1’ or ‘alarm 2’.
3. Let’s take set alarm 1 as example, while ‘alarm 1’ is showing up, press SELECT to
confirm.
4. While it shows: “Alarm 1 Setup”, press SELECT to confirm.
5. Now, follow your radio instruction, configure the following parameters:
∗ Alarm states: On or Off, press  or

to ‘On’, press SELECT.
∗ On Time: 00:00 (alarm sound time )
∗ Duration Time: 15/30/45/60/90mintues
 Note: The alarm will sound until the selected duration time is finished.
∗ Source: DAB, FM or Buzzer
∗ Set Days: Daily, Once, Weekends or Weekdays
∗ Volume level: remember don’t set your radio volume level to zero (Mute), otherwise,
when alarm is coming, it won’t be heard.
• Postpone Alarm Off:
When alarm is coming, press SELECT to postpone alarm, repeatedly press SELECT to
postpone alarm 5, 10 minutes in turn. Radio will perform counting backward and sound
again after it reaches this setting.
• Turn off Alarm off:
When alarm is sound, press STANDBY to turn alarm off.
• To cancel the Alarm:
Refer to above steps1-5, set ‘Alarm states’ to ‘Off’, and then follow your radio’s
instructions, until it shows ‘Alarm saved’.
SW Version
 Note: The helpdesk may ask you for the software version of your product.
It can be activated from < System >  < SW version >. Press SELECT to confirm.