DAB+/DAB, FM Digital Radio Instruction Manual IKR2111DAB 1
Introduction Thank you for buying this product, which is designed to give you many years of trouble-free service. You may already be familiar with using a similar unit, but please take time to read these instructions. Safety is important Your safety and the safety of others is important. Please therefore, ensure you read the “Safety Instructions” before you operate this unit. Ensure that you read all of the safety instructions before using this unit.
Contents Introduction ............................................................................................................................................. 2 Safety Considerations ...................................................................................................................................... 2 Contents .......................................................................................................................................................... 3 Front Overview ......
Front Overview Control All mode Press to turn on/off Radio POWER When alarm is coming, press to turn alarm off MODE Press to shift to another mode MENU Press to Main menu and system settings ∗ Press ∗ While in system setting like set time, set alarm etc. Press through options, press SELECT/NAV confirm.
Unit Back and Side Overview 1. Remove the cable from the power socket if any. 2. Remove the battery compartment cover at the back of the radio. 3. Fit 4 new batteries, referring to the markings inside the battery compartment. Note: a. Please do not reverse any battery and do not mix battery types, also do not mix old and new batteries. b. If you won’t use the radio for an extended period, please remove the batteries to avoid damage. 4. Cover the battery door. 5.
Positioning your DAB Radio Place your radio on a flat / stable surface that is not subject to vibrations. Avoid the following locations: Where it is exposed to direct sunlight. Where it is close to heat radiating sources. Where the humidity is high and ventilation is poor. Where it is dusty. Where it is damp or there is a possibility of water dripping or splashing onto unit. Adjusting the Antenna The aerial should be extended to ensure good reception in both DAB and FM radio modes.
How to Show the Signal Strength 1. Press MENU, while it indicates ‘Display’, press SELECT/NAV to confirm. 2. Press or to ‘Signal strength’, press SELECT/NAV to confirm, the LCD screen will display a signal bar to show the signal strength. The indicator on the signal bar shows the minimum acceptable signal level. Note: Stations with signal strength below the minimum signal level will not provide a steady stream of audio.
Setting Station Presets Your radio can store 10 DAB+ & 10 FM station presets. To store presets: Note: this is the same for DAB+ and FM Radio stations. 1. While playing your favourite station, press and hold PRESET until it says ‘Preset Store <1: (Empty)>’. 2. Press or to cycle through preset stations 1-10 and then press SELECT/NAV to confirm your preferred preset number, it would indicates ‘Preset # stored’. Selecting a Preset Station To select a stored station: 1.
Audio Setting 1. Press MENU and then press to select Audio Setting menu, press SELECT/NAV to confirm. Note: if you choose Stereo Allowed, the sound output is stereo, while Forced Mono means the sound output is Mono. 2. Press or to select your preferred option, and then press SELECT/NAV to confirm. How to browse station information 1. Press MENU, while it indicates ‘Display’, press SELECT/NAV to confirm. 2.
How to Set Alarm Note: ensure that clock is set already. 1. Press MENU and then press ‘Alarm 1’. 1. To set alarm 2, continue step1, press to select Alarms menu, press SELECT/NAV to confirm, it will says to ‘Alarm 2’, now let’s take set alarm 1 as example. or 2. While your radio says‘Alarm 1’, press SELECT/NAV to confirm. 3. Now ‘Alarm 1 Setup’ should be showing up, press SELECT/NAV to confirm, your radio will run into ‘Alarm 1 Wizard’. 4.
∗ Under Standby Mode 1. Refer above step1, while it says ‘Backlight ’, press or to ‘Standby’, press SELECT/NAV to confirm. 2. Refer above step 2-3 setting it, you can also choose low to reduce any light disturbance in case you are staying in a dark room. How to Set Language 1. Press MENU and then press 2. Press or or to select Language menu, press SELECT/NAV to confirm. to select your desired one, press SELECT/NAV to confirm.
Specification Specifications ……………………………………………….. Speaker power…………………………………………..….. Frequency Range .…………………………………………. DAB, DAB+ and FM digital radio 0.5W FM: 87.5-108MHz DAB+: 174 – 240MHz Earphone jack…………………………………….……..….. Frequency Response………………………………....……. 32ohm 80Hz to 20kHz (- +6dB) LCD Display .……………………………..…………………. High resolution display Power Supply .………………………………………………. AC Power Input: 100-240VAC, 50-60Hz (please use our provided adapter) Dimension .……………………………….………………….
