Operation Manual

Setting Station Presets

Your radio can store 10 DAB+ & 10 FM station presets. To store presets:

 Note: this is the same for DAB+ and FM Radio stations.

1. While playing your favourite station, press and hold PRESET until it says ‘Preset Store <1: (Empty)>’.

2. Press

or to cycle through preset stations 1-10 and then press SELECT/NAV to confirm

your preferred preset number, it would indicates ‘Preset # stored’.

Selecting a Preset Station

To select a stored station:

1. Press MODE to shift to relative mode.

2. Press PRESET, it says ‘Preset Recall <1: xxxxxx>’.

3. Press

or to your preferred preset station, and then press SELECT/NAV to confirm.

FM MODE

1. Press MODE to switch to FM Mode from DAB Mode.

2. Once in FM mode, it will start at the beginning of the FM frequency range

(87.50MHz). Or it will play the last FM station you were listening to.

How to Manually Scan

Make sure there is no other setting is going on, the path of manual scan is:

1. Press SELECT/NAV to activate the navigate function of and ,

2. Press or to manually scan FM frequency.

How to Autoscan

 Note: in order to have your radio detect strong signal stations only, please refer below to set ‘Scan setting’ to ‘strong stations

only’ before you conduct ‘Autoscan’.

1. Press SELECT/NAV to activate the navigate function of and ,

2. Press and hold or to backward or forward scanning.



Note: 1. The display will show the frequency changing until it stops on the

next station.

2. After it reaches the end of the frequency range, it will go back to the

start frequency.

Scan Setting

1. Press MENU and then press to select Scan Setting menu, press SELECT/NAV to confirm.



Note: if you choose Strong Stations only, the menu will show only the

stations with strong signal strength, while All Stations means all detected

stations will be shown.

2. Press or to select your preferred option, and then press SELECT/NAV to confirm.