Operation Instructions

3130
Method of usage Method of usage
·In the process of massage, press the power switch key to immediately turn off all
massage functions, the backrest and the calf are reset, the massage time is up,
and all massage functions are immediately turned off, and the backrest and the
calf are not reset.
·Cut off the power supply of the whole machine, the figure (schematic diagram of
the whole machine power cut).
Schematic diagram of the whole machine power turning off.
Schematic diagram of unplugging the whole machine wiring.
Schematic diagram of unplugging the power plug.
1. Find out the connector and air tube from the bottom of the seat frame and pass
out from the middle of the seat frame (Figure 1).
2. Take out the armrest from the package and make the connector and air tube on
the armrest correspond to the connector and air tube at the bottom of the seat
frame one by one (butt joint according to the mark on the physical butt joint line)
(Figure 2).
Figure 1 Figure 2
Figure 3 Figure 4
3. The connector and air tube on the armrest are inserted into the connector and air
tube at the bottom of the seat frame, which should be in place and firm (Figure 3).
4. After the air tube and connector are docked, insert them into the bottom of the
seat frame and take care to avoid the air tube from being folded (Figure 4).
5. Hold the armrest with both hands, first hook the front end of the armrest, hang it
in the seat frame steel and press down the front end of the armrest. (Figure 5)
6. Then, align the male buckle on the rear end of the armrest with the female buckle
on the capsule, insert the rear end of the armrest into the female buckle of the
capsule and snap it tightly (note that the fit gap of the armrest capsule should be
even). (Figure 6)
Figure 5 Figure 6
7.Fix the rear end of the armrest tightly with a M6*20 screw (Figure 7).
8.Pull the upper arm holster away and fix it with a M6*20 screw (Figure 8);
Figure 7
Figure 8
9. Align the mounting holes that fix the steel frame at the front end of the armrest,
and then use the provided 4# Allen wrench to fix and tighten the armrest and the
seat frame steel piece with two M5×14 black zinc environmental friendly hexagon
socket head cap screws and a 6×12×1.5 black zinc environmental friendly flat pad
(Figure 9).
10. Install the screw hole plug at the back end of armrest (Figure 10).
Figure 9 Figure 10
V. Turn off power, stop massage
VI. Installation Instructions for Armrests
POWER INPUT
ON/
O
F
F
POWER INPUT
O
N
/OF F