User Manual

Iridium Communications, Inc. Information Contained in this Guide
Iridium 9523 Product Developers’ Guide is Subject to Change Without Notice
Revision 2.6
Iridium Communications, Inc. Distribution of Guide Restricted
Proprietary & Confidential Information Page 77 of 115 to Product Developers
Only
9523
Exec Command: +SBDWT=[<text message>]
This command is used to transfer a text SBD message from the FA to the single mobile originated buffer
in the Iridium 9523.
The text message may be entered on the command line:
For example, “AT+SBDWT=hello”
The length of <text message> is limited to 120 bytes. This is due to the length limit on the AT
command line interface.
The message is terminated when a carriage return is entered
Alternatively, the text message may be entered separately:
Upon entering the command “AT+SBDWT”, the Iridium 9523 will indicate to the FA that it is
prepared to receive the message by sending the string “READY<CR><LF>” (hex 52 45 41 44 59
0D 0A) to the FA
Once the FA receives the READY indication, the text message must be sent, terminated by a
carriage return
The length of the text message entered in this way is limited only by the maximum mobile-
originated message length of 1960 bytes
The mobile originated buffer will be empty upon power-up
If any data is currently in the mobile originated buffer, it will be overwritten
Command Response:
For the “AT+SBDWT” form:
0 SBD message successfully stored in mobile originated buffer
1 SBD message write timeout. No terminating carriage return was sent within the transfer
period of 60 seconds.
For the “AT+SBDWT=<text message>” form:
OK SBD message successfully stored in mobile originated buffer
ERROR An error occurred storing SBD message in mobile originated buffer
5.7.104 +SBDDET - Short Burst Data: Detach
Exec Command: +SBDDET
Initiates an SBD session to detach the Iridium 9523 from the Gateway.
Command Response:
+SBDDET:<status>,<error>
where:
<status>:
0 Detach successfully performed
1 An error occurred while attempting the detach
<error>:
Gateway-reported values: