User's Manual

Iridium Satellite LLC
9601 Transceiver –AT Command Reference
Iridium Satellite LLC Proprietary & Confidential Information Page 6 of 51
Information contained herein is preliminary and subject to change without further notice
2.10 &Kn –Flow Control (modified)
Select the flow control method between the 9601 and DTE. Flow control is only
applied to the transfer of SBD message data; it does not apply to AT commands
and their responses.
0 Disables flow control.
3 Enables RTS/CTS flow control (default).
2.11 &V –View Active and Stored Configuration
View the current active configuration and stored profiles.
2.12 &Wn –Store Active Configuration
Store the active profile in non-volatile memory. This is used to store user
configurations for later use.
0 Store current (active) configuration as profile 0.
1 Store current (active) configuration as profile 1.
2.13 &Yn –Designate Default Reset Profile
Select profile for use after power-up.
0 Select profile 0 (default).
1 Select profile 1.
2.14 %R –Display Registers
Display all the S-registers in the system.
2.15 *F –Flush to Eeprom (new)
Flush all pending writes to Eeprom, shut down the radio, and prepare the 9601 to
be powered down. The command returns OK upon completion, at which point it is
safe to remove the power without losing non-volatile data.
Note: This command stops the 9601 from responding to any more commands, but
does not actually power it down. The only way to power down the 9601 is for the
FA to remove the power or to de-assert the on/off control line.
Note: After an SBD session, the new SBD MOMSN is always flushed to Eeprom
before the +SBDI result is issued.