Operation Manual

IRISDocument
TM
Server 9.5 – User Guide
31
complete Watched Folder configuration will be pre-
configured and the interface will open immediately.
In case you want to use a Canon imageRUNNER to send
documents to IRISDocument, make sure you install the
Workgroup add-on and select the Workgroup initial
data option.
You are recommended not to change the pre-
configured settings that are applied (except for the
Watched Folder location should you want to change this).
The pre-configured image folder of the Watched Folder is
C:\IRISDocument_9.5\WatchedFolder01\Input.
When configuring the Canon imageRUNNER, you will
need to enter the name of the Watched Folder. In this case:
\Input. Refer to the sections Configuring a Canon
imageRUNNER with iSend functionality or
Configuring a Canon imageRUNNER Advance for
more information.
When creating additional Watched Folders, make sure to
apply the same settings as in the pre-configured one.
Note: the Canon imageRUNNER must have reading and
writing rights to the Watched Folder in order to be able to
send documents to it. If the user account that is used to
configure the Canon imageRUNNER (in the remainder of
this documentation referred to as the MFP administrator) is
not the same as the user account on which IRISDocument
is installed and configured, then the Watched Folder must
be shared with the MFP administrator. Refer to the section
Sharing folders for more information on how to share
folders.