Datasheet
6
7
To disconnect MG100 from a Mac
• Press COMMAND-E or select [Eject “MG100”] in the File menu in Finder. If you have a
mouse with two mouse buttons, right click on MG100 icon on the desktop and
choose [Eject “MG100”].
• Wait until the MG100 icon disappears from the desktop.
• Remove MG100 from your Mac.
Note: Disconnecting MG100 without properly going through “Eject” process may result in
loss of data.
Using MG100
Basic Controls
To turn on MG100
• Press and hold ( ).
To turn off MG100
• Press and hold ( ).
Note: MG100 will automatically power off three minutes after it was put on pause by
default.
To change the volume
• Press (+) to raise or (-) to lower the volume. Hold either button to rapidly raise or
lower the volume.
To switch between MTP and MSC modes
• While MG100 is plugged into your computer, press the Menu ( ) button to
switch between the MTP and the MSC modes.
Note: If you are using Windows98 SE and need to install the USB driver manually, please
refer to Microsoft Knowledge Base or to MPIO Web Support.
Disconnecting MG100
To disconnect MG100 from a PC
• Place mouse cursor on “Stop a Hardware Device” icon in the system tray, and click
right mouse button.
• Select “Stop USB Mass Storage Device.”.
• Select USB Mass Storage Device from the list of hardware, and click the [Stop]
button.
• When the “Stop a Hardware Device” window appears, select MPIO MG100 USB
Device.
• Finally, click [OK] and disconnect the USB cable.
Windows XP:
Disconnect the USB cable when the “Safe to remove hardware” message appears.
Windows 2000:
Disconnect the USB cable by clicking the [OK] button after the “Safely Remove Hardware”
message appears.
Note: Disconnecting MG100 without going through the above steps may result in loss of
data.