Operation Manual

28
Chapter4 Other Information
1. Connect the product to the USB jack of your
PC using the USB cable and run iriver plus 3.
2. Select [Tools > Portable Device > Initialize Disk]
and click [Start] when the message to conrm
initialization appears.
3. The initialization process is completed and the
product is disconnected from your PC.
Note
Do not disconnect the product from PC while downloading
rmware upgrade le. After the download is completed,
disconnect the cable to activate the rmware upgrade.
During rmware upgrade, the amber LED light will be
turned on.
Do not operate the product in this process.
It may case a malfunction.
If your are using the latest rmware version, the
message to conrm latest version appears.
When connect the product to your PC, if there is latest
rmware, the instruction message appears automatically.
Using iriver plus 3
Initializing Disk
1. After connecting the product to the USB jack of
your PC using the USB cable, run iriver plus 3.
The PC should be connected to internet.
2. Select [Tools > Portable Device > Firmware Upgrade]
and complete the upgrade process following
the on-screen instructions.
Upgrading Firmware
Note
You need to backup the necessary les before
initialization as formatted les cannot be recovered.