User's Manual

16 Basic Operations Basic Operations 17
3
Charging the player
Turn on your PC and connect the W10 to it using the USB cable.
Connecting products
Note
• While the product is connected to PC using the USB cable, the integrated battery is will be charged automatically.
Do not use any other USB cable that is not provided with the product.
It may case a malfunction.
• Check if the W10 is connected to a high-power USB 2.0 port.
Some low-power USB ports built in some peripheral devices such as certain keyboards and USB hub without
integrated power may not provide enough power to charge.
• While the PC is switched to standby mode, the product may not be charged.
• Charge the product only in room temperature. The product may not be charged in extremely hot and cold place.
• The available usage time of charged battery becomes gradually short after sometime.
• The product will be fully charged within 3 hours. (Based on fully discharged and stop mode)
• The charging time might be extended when you use the product while charging.
Inserting/Removing Mini SD card
Open the card slot cover after turning off the product.
Insert and slightly press a Mini SD card to the
direction as shown below.
Press the card again to remove it.
Connecting products
5
Recommended types of Mini SD card
Manufacturer: SanDisk
4
Note
• Be sure to insert/remove a Mini SD card after turning off the product.
• Do not use excessive power to insert a Mini SD card.
• Do not remove a Mini SD card while it is being used.
• Do not insert or remove a Mini SD card repeatedly.
• If you insert a Mini SD card improperly, it can cause a
malfunction of the product or the card cannot be removed.
Note
• Using improper type of Mini SD card may cause a
malfunction of the product.
• Transfer speed of Mini SD card is subject to change
depending on PC.
• Always backup valuable data rst since formatting Mini
SD card will delete all data in the card.
• Do not turn off the product or remove a Mini SD card while it
is being formatted.
• It is recommended to format a Mini SD card as a FAT32
system in case it is less than 2 GB.
• If a Mini SD card was formatted by the product, reset the
product after disconnecting a USB cable and connect the
cable again.
• Format the Mini SD card when it is not detected or causes
a malfunction.
• Mini SD card is not enclosed with the product. Please
purchase it separately.