Use and Care Manual

Braava jet™ Owner’s Guide 31
EN
30 For Customer Care go to www.irobot.com/support
EN
Troubleshooting
Repeating Error Messages
If your robot remains on after an error occurs, press the bumper toward the body
of the robot once to repeat the message. If your robot has turned o after an
error occurs, press CLEAN to turn it on. If the error is ongoing, the robot will repeat
the message. Visit www.irobot.com/support to view a complete error table.
Rebooting Instructions
For some errors, rebooting Braava jet may resolve the problem. To reboot Braava jet,
press and hold CLEAN for 10 seconds until you hear an audible tone. Take out the
battery and insert it again. Press CLEAN again to turn the robot back on.
Braava jet will tell you something is wrong by alerting you
with sounds and lights. If the problem is not resolved,
learn more online at www.irobot.com/support or contact
Customer Service at [phone].
Precision Jet Spray Troubleshooting
If the robot is not spraying or is spraying unevenly and you have checked that the
tank has enough water and can hear the pump running, contact Customer Service
at [phone].
Water Level Troubleshooting
If you encounter problems with the amount of water Braava jet uses on your
floors in wet mopping or damp sweeping modes, contact Customer Service at
[phone].