Owner’s Guide
Table of Contents What’s In the Box 2 Robot Anatomy 4 EN 8 Setup Guide Choosing the Right Braava jet Pad 18 How iRobot Braava jet Cleans 20 Tips for Best Performance 28 Troubleshooting 30 Regular Robot Care 32 Safety and Compliance Information 38 ™ Braava jet™ Owner’s Guide 1
What’s In the Box EN EN • iRobot Braava jet™ Robot • Lithium Ion Battery • Battery Charger • iRobot Braava jet Cleaning Pads (type and quantity of cleaning pads may vary by model) • (2) Wet Mopping Pads (Blue) • (2) Damp Sweeping Pads (Orange) • (2) Dry Sweeping Pads (White) Pad and battery quantities may vary by model 2 For Customer Care go to www.irobot.
Robot Anatomy EN Top View - Front EN Top View - Back Handle CLEAN Button Pad Eject Button Tank Cap Precision Jet Spray Nozzle Battery Braava jet Cleaning Pad 4 For Customer Care go to www.irobot.
Robot Anatomy EN Bottom View Front Cliff Sensors Pad Reader EN iRobot Braava jet Cleaning Pads Wet Mopping (Blue) Damp Sweeping (Orange) Pad Tracks Dry Sweeping (White) Wheels Rear Cliff Sensors Washable Wet Mopping (Blue) (Included with select models. Also available for purchase as an accessory.) 6 For Customer Care go to www.irobot.
Setup Guide EN Follow these simple steps to get started with your Braava jet™ Mopping Robot. 1 EN Charge Insert Charge & Insert the Battery • Remove the battery and put it in the battery charger. • The indicator light will blink amber while the battery is charging. The light will switch to solid green when the battery is fully charged. • The wall charger automatically goes into low-power mode when the battery is fully charged to maintain the life of the battery and limit power usage.
Setup Guide EN 2 Pad Type Select a Braava jet Cleaning Pad • Choose a cleaning pad that matches how you want to clean your floor. • Your robot comes with a sample pack of Wet Mopping, Damp Sweeping, and Dry Sweeping Braava jet cleaning pads. • Braava jet will automatically recognize the pad and adjust its cleaning behavior based on the pad you choose. Cleaning Tip: Before using a Wet Mopping or Damp Sweeping pad, use a Dry Sweeping pad or vacuum to clean loose debris.
Setup Guide EN 3 Slide in a Cleaning Pad • Slide a Braava jet pad into the track on the bottom of the robot until it clicks into place. • You can attach a Braava jet pad from either side of the robot. 4 EN Fill the Robot with Water • • • • Fill the robot if you choose Wet Mop or Damp Sweep. Lift the robot handle to find the tank cap and lift and swivel it open. Slowly fill the tank to the top with warm water. Turn the cap back and close. Lower the robot handle before starting the robot.
Setup Guide EN 5 Just Press CLEAN EN See How iRobot Braava jet Cleans section for more details on placement and cleaning pattern behavior. • Place your robot in the lower left corner of the area you want to clean, about a foot away from any walls. • Press CLEAN once to wake up the robot. Press CLEAN again to start the cleaning cycle. • The robot will clean up to 150 ft2 while mopping, and up to 200 ft2 while damp or dry sweeping.
Setup Guide EN 6 EN Eject the Cleaning Pad and Prepare iRobot Braava jet for Next Use • To eject the cleaning pad without touching the dirt, lift the handle and pull back on the Pad Eject Button. Disposable cleaning pads can be dropped directly into the trash and Washable Cleaning Pads (sold separately) can be dropped into the laundry bin. • Remove the battery and put it in the wall charger so it can charge for the next cleaning. • Empty the water tank before storing the robot.
Choosing the Right Braava jet™ Pad EN Choose the right cleaning pad for your cleaning needs. Pad Type Wet Mopping (Blue) Damp Sweeping (Orange) Cleaning Motion and Wetness Level EN RECOMMENDED FOR OVERVIEW Fresh Scent Dust Hair Dirt Stains* Cleaning Agent Cleaning Agent Dry Sweeping (White) Washable Wet Mopping (Blue) (Included with select models. Also available for purchase as an accessory.) *Tested on dried coffee and soda. 18 For Customer Care go to www.irobot.
How iRobot Braava jet™ Cleans EN EN Braava jet is designed to intelligently navigate and clean typical kitchens and bathrooms each time it runs, up to 150 ft2 while wet mopping and up to 200 ft2 while damp and dry sweeping.* Where to Place the Robot in a Room Place the robot in the lower left of the area you want it to clean. The robot will systematically clean the area to the right and in front of where it started.
How iRobot Braava jet™ Cleans EN EN 22 For Customer Care go to www.irobot.
How iRobot Braava jet™ Cleans EN • Braava jet does not spray furniture or walls. Before the robot sprays, it will back up to ensure it’s only spraying a portion of the floor it knows is clear. • As Braava jet finds edges, chair legs, and other obstacles, it will clean around them and then return to its original path and resume cleaning. • After Braava jet has cleaned the entire space, it finishes the job by cleaning along edges, walls, furniture, and other obstacles a second time.
How iRobot Braava jet™ Cleans EN EN Creating an Invisible Barrier You can create an invisible barrier with the Virtual Wall® Mode so that the robot will avoid cleaning part of a room or a different floor type. • Begin with the robot powered off. When placing the robot, note that the invisible line will be created in line with the back of the robot. • To activate Virtual Wall Mode, start with a powered-off robot and press and hold the CLEAN button until two blue lines appear on the top of the robot.
Tips for Best Performance EN EN General Cleaning Tips • For best results, use a Dry Sweeping Pad or vacuum to pick up dirt and dust before running your robot with a Wet Mopping or Damp Sweeping Pad. • To pause your robot during a cleaning cycle, press the CLEAN button. To resume the cleaning cycle, press the CLEAN button again. • Do not pick up and move your robot while it is cleaning – the robot will end its cleaning run if you do.
Troubleshooting EN Braava jet will tell you something is wrong by alerting you with sounds and lights. If the problem is not resolved, learn more online at www.irobot.com/support or contact Customer Service at (877) 855-8593. Repeating Error Messages If your robot remains on after an error occurs, press the bumper toward the body of the robot once to repeat the message. If your robot has turned off after an error occurs, press CLEAN to turn it on.
Regular Robot Care EN Follow these tips to keep your iRobot Braava jet running at peak performance. EN Cleaning the Wheels Pull off any visible debris or hair that gathers around the wheels. Cleaning the Cliff Sensors and Pad Reader Clean the sensors on the bottom of your robot with a damp cloth. Front Cliff Sensors Pad Reader Wheels Rear Cliff Sensors 32 For Customer Care go to www.irobot.
Regular Robot Care EN Cleaning the Body of the Robot Use a damp cloth to lightly wipe off any dirt on its body or bumper. EN Cleaning the Precision Jet Spray Nozzle Wipe clean with a damp cloth. Precision Jet Spray Nozzle 34 For Customer Care go to www.irobot.
Regular Robot Care EN Cleaning the Tank If you notice an odor in the tank, fill the tank with hot tap water. Do not use boiling water. Close the cap and lightly shake the robot. Rinse the tank and repeat. Allow the tank to dry with the cap open before using your robot. EN Caring for Washable Cleaning Pads (sold separately) After using washable cleaning pads to clean, hand washing and air drying is recommended for regular maintenance. The cleaning pad can be washed up to 50 times* before replacing.
Safety and Compliance Information EN THIS APPLIANCE CAN BE USED BY CHILDREN AGED FROM 8 YEARS AND ABOVE AND PERSONS WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE IN A SAFE WAY AND UNDERSTAND THE HAZARDS INVOLVED. CHILDREN SHALL NOT PLAY WITH THE APPLIANCE. CLEANING AND USER MAINTENANCE SHALL NOT BE MADE BY CHILDREN WITHOUT SUPERVISION.
Safety and Compliance Information EN EN The symbol on the product or its packaging indicates: Use Restrictions Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local authority for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being.
Safety and Compliance Information EN Battery and Charging • Before every use, check the battery pack for any sign of damage or leakage. Do not charge damaged or leaking battery packs. • Charge indoors only. • Only use the included battery charger to charge the iRobot Braava jet battery. • Charge using a standard outlet only. Product may not be used with any type of power converter. Use of other power converters will immediately void the warranty.
Safety and Compliance Information EN For EU Declaration of Conformity information, visit www.irobot.com/compliance. FCC Compliance Information: • This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • This device complies with Industry Canada license-exempt RSS standard(s).
©2016 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved. iRobot and Virtual Wall are registered trademarks of iRobot Corporation. Braava jet is a trademark of iRobot Corporation.