Installation Manual

End Product Labelling
When the module is installed in the host device, the FCC/IC ID label must be visible
through a window on the final device or it must be visible when an access panel, door or
cover is easily removed. The label shall state to following:
“Contains FCC ID: UFE-AXFY1”
“Contains IC 6652A-AXFY1”
The FCC ID and IC ID can be used only when all FCC/IC compliance requirements are
met.
Alternatively, electronic labelling method as documented in KDB 784748 may also be
used.
Antenna Installation
1. The antenna must be installed such that 20cm is maintained between the antenna
and users,
2. The transmitter module may not be co-located with any other transmitter or
antenna,
3. Only antennas of the same type and with equal or less gains as shown below may be
used with this module. Other types of antenna and/or higher gain antennas will
require additional authorization for operation.
In the event that these conditions cannot be met, then the FCC/IC authorization is no
longer considered valid and the FCC ID/IC ID cannot be used on the host device. In
these circumstances, the OEM integrator will be responsible for re-evaluating the host
device (end-product), including the transmitter and obtaining a separate FCC/IC
authorization.
5. Tested Antenna Information:
Antenna
No.
Brand Model Gain (dBi) Antenna Type Frequency Range
(GHz)
1 (Internal) iRobot AXF-Y1 4 PCB Internal
Trace antenna
2.4-2.4835