Robot aspirateur Robot aspirador e6 Owner’s Guide Guide du propriétaire Guía del usuario WC#: 4632506v1
Safety Information Important Safety Information SAVE THESE INSTRUCTIONS WARNING: When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS WARNING: To reduce the risk of injury or damage, read and follow the safety precautions when setting up, using and maintaining your robot.
WARNING: Indicates a hazardous situation that, if not avoided, could result in death or serious injury. EN CAUTION: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. NOTICE: Indicates a hazardous situation that, if not avoided, could result in property damage. GENERAL WARNING • Your robot is not a toy. Small children and pets should be supervised when your robot is operating. • Do not sit or stand on your robot or Home Base charging station.
• Only use the included battery charger to charge the iRobot ABL-D1 battery. Other type of batteries may burst causing injury. Always contact Customer Care for the correct replacement of your battery. Battery Charger model 17070: Input AC 100240V, 50-60Hz, 0.68A; 33W. Output DC 20.5V, 1.25A. • To prevent the risk of your robot falling downstairs, ensure that the Home Base Charging Station is placed at least 4 feet (1.2 meters) away from stairs.
About your Roomba® Robot Vacuum Top View Home Base EN Faceplate RCON Sensor Handle Dust Bin and Filter Light Touch Sensor Bin Release Button Bottom View Multi-Surface Brushes Brush Caps Cliff Sensor Dust Bin and Filter Edge-Sweeping Brush Brush Frame Release Tab Cliff Sensor 1 For more information, visit global.irobot.
Using Your Roomba® Robot Vacuum Place the Home Base® charging station WARNING: To prevent the risk of your robot falling downstairs, ensure that the Home Base Charging Station is placed at least 4 feet (1.2 meters) away from stairs. Place the Home Base in an open, uncluttered area leaving the following distances around the Home Base: • A t least 1.5 feet (0.
Accessories EN • Y ou can use the Spot Clean feature to have the robot go after specific spills. Just place the robot in the center of the debris and press (Spot Clean). The robot will clean the area by spiraling outward about 3 feet (1 meter) and then spiral inward to end where it started. • Keep the robot on the Home Base® charging station so it’s always ready to clean when you need it.
Care and Maintenance Care and Maintenance Instructions To keep your Roomba® robot vacuum running at peak performance, perform the procedures on the following pages. There are additional instructional videos in the iRobot HOME App. If you notice the robot picking up less debris from your floor, empty the bin, clean the filter and clean the brushes. Emptying the Bin Cleaning the Filter 1 Press bin release button to remove bin. 1 Release the bin. Remove the filter by grasping both ends and pulling out.
Cleaning the Full Bin Sensors EN 1 2 Rinse the bin using warm water. Remove and empty the bin. Note: Bin is not dishwasher safe. 2 Wipe the inner sensors with a clean, dry cloth 3 Cleaning the Front Caster Wheel 1 2 Pull firmly on the front wheel to remove it. 3 Reinstall all parts when finished. Make sure the wheel clicks back into place. Remove any debris from inside the wheel cavity. Make sure bin is completely dry. Reinsert filter and place bin back in the robot.
Cleaning the Multi-Surface Brushes 1 Pinch the brush frame release tab, lift the tab, and remove any obstructions. 2 Remove the brushes from the robot. Remove the brush caps from the ends of the brushes. Remove any hair or debris that has collected beneath the caps. Reinstall the brush caps. 3 Remove any hair or debris from the square and hexagonal pegs on the opposite side of the brushes. 4 Remove the bin from the robot and clear any debris from the vacuum path.
Troubleshooting EN Your Roomba® robot vacuum will tell you something is wrong with a twotone alert, a spoken message and a blinking troubleshooting indicator ( ). Follow the audible instructions. More detailed support and videos, are available in the iRobot HOME App and at global.irobot.com. To reboot your robot, press and hold the (Home) and (Spot Clean) buttons for 10 seconds until all indicators turn off, then release. When you release the buttons, you will hear a tone to confirm a successful reboot.
iRobot Customer Care USA & Canada If you have questions or comments about your Roomba® robot vacuum, please contact iRobot before contacting a retailer. EN You can start by visiting global.irobot.com for support tips, frequently asked questions and information about accessories. This information can also be found in the iRobot HOME App. If you need further assistance, call our Customer Care team at (877) 855-8593.
Regulatory Information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada license-exempt RSS standard(s).
