Owner's Manual
Table Of Contents
II
Regulatory Information
This
device complies with
part
15
of
the FCC
Rules.
Operation
is
subject
to
the following
two
conditions:
(1)
This
device
may
not
cause harmful interference,
and
(2)
this device must
accept
any interference received, including interference
that
may
cause
undesired operation.
This
device contains a
licence-exempt
transmitter/receiver
that
complies with Innovation, Science
and
Economic Development
(ISED)
Canada's
licence-exempt
RSS(s).
Operation
is
subject
to
the
following
two
conditions:
l)
This
device may
not
cause interference,
and
2)
this
device must
accept
any interference, including interference
that
may
cause undesired operation
of
the device.
• Changes or modifications
not
expressly approved by iRobot
Corporation could void the user's authority
to
operate the equipment.
•
This
equipment
has been tested
and
found
to
comply
with the limits
for a Class B
digital
device, pursuant
to
part
15
of
the FCC
Rules.
These limits are designed
to
provide reasonable protection
against
harmful interference in a residential installation.
This
equipment
generates,
uses
and
can
radiate
radio
frequency energy and,
if
not
installed
and
used
in
accordance
with
the
instructions, may cause
harmful interference
to
radio
communications. However, there
is
no
guarantee
that
interference
to
radio
communication
will
not
occur
in
a
particular
installation. If this
equipment
does cause harmful
in-
terference
to
radio
or
television reception, which
can
be
determined
by turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the interference by
one
or
more
of
the
following measures:
©2020
iRobot Corporotion, 8 Crosby Drive, Bedford,
MA
01730
USA.
All rights reserved.
• Reorient
or
relocate
the
receiving antenna.
• Increase
the
separation between
the
equipment
and
receiver.
•
Connect
the
equipment
into
an
outlet
on a circuit different from
that
to
which
the
receiver
is
connected.
• Consult
the
dealer or an experienced radio/TV technician
for help.
• Under Industry
Canada
regulations, this radio transmitter
may
only
operate
using an antenna
of
a
type
and
maximum (or lesser)
gain
approved
for the transmitter by Industry
Canada.
To
reduce
potential radio interference
to
other
users, the antenna type
and
its
gain
should
be
so chosen
that
the equivalent isotropically
radiated
power (e.i.r.p.)
is
not
more
than
the necessary for
successful communication.
• FCC Radiation Exposure Statement:
This
product
complies with
FCC
§2.1091
(b) for mobile device
RF
exposure limits, set forth
for
an
uncontrolled environment
and
is
safe
for
the intended operation
as described in this manual. Per FCC requirements, maintain a
distance
of
more
than 8 inches (20cm) between any person
and
the
host device (Roomba robot).
•
ISED
Radiation Exposure Statement:
This
product
complies with
the
Canadian
Standard
RSS-102
for
portable
RF
exposure limits, set
forth for
an
uncontrolled environment
and
is
safe for
the
intended
operation as described
in
this manual. Per
ISED
requirements,
main-
tain
a distance
of
more
than
8 inches (20 cm) between any person
and
the
robot.
For
battery
recycling
go
to
call2recycle.org;
~
~
orcall
1-800-822-8837
~
W
iRobot, Roombo, iAdopt, Home
Base
and
Virtual Wall
are
registered trademarks of iRobot Corporation. AeroVac
and
Dirt Detect
are
trademarks
of
iRobot Corporation.
10 For
more
information,
visit
www.irobot.com/Roomba600
WC: 4534066
vG