600 Series Owner’s Guide
Important Safety Instructions This owner's guide includes information for Roomba vacuum cleaner Model(s): 670-679 and 690-699. SAVE THESE INSTRUCTIONS WARNING: When using an electrical appliance, basic precautions should always be followed, including the following: EN READ ALL INSTRUCTIONS BEFORE USE WARNING: To reduce the risk of injury or damage, read and follow the safety precautions when setting up, using and maintaining your robot.
WARNING: Indicates a hazardous situation that, if not avoided, could result in death or serious injury. CAUTION: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury. EN NOTICE: Indicates a hazardous situation that, if not avoided, could result in property damage. GENERAL WARNING • Your robot is not a toy. Small children and pets should be supervised when your robot is operating. • Do not sit or stand on your robot or Home Base.
• Use only as described in this manual. • Only use the battery charger model 17070 to charge the iRobot model 1800LI battery, Battery Charger model 17070: Input AC 100-240 VDC, 50-60 Hz, Output 20.5 VDC, 1.25A. • Only charge one of the following iRobot batteries: maximum 14.4V, max 2000mAh Ni-MH or maximum 14.4-14.8V, max 3300mAh Li-ion battery. Other type of batteries may burst causing injury. Always contact Customer Care for the correct replacement of your battery.
This symbol on the battery indicates that the battery must not be disposed of with unsorted common municipal waste.
Table of Contents EN Important Safety Information................................................................................................i About Your Roomba® ............................................................................................................ 2 Using Your Roomba®.............................................................................................................. 3 Accessories............................................................................................
About your Roomba Top View EN Home Base RCON Sensor Faceplate Handle* Bin Release Button Light Touch Sensor Charging Contacts Dust Bin and Filter *Select models only Bottom View Buttons & Indicators Troubleshooting Indicator Wi-Fi Indicator Battery Indicator Spot Button CLEAN/ Power Button Dock Button 2 RCON Sensor For more information, visit www.irobot.
Using your Roomba Positioning the Home Base® Place the Home Base in an open, uncluttered area leaving the following distances around the Home Base: • A t least 1.5 feet (0.5 meters) on each side of the Home Base • At least 4 feet (1 meter) in front of the Home Base, and at least 4 feet (1 meter) away from stairs • At least 8 feet (2.
Accessories The Dual Mode Virtual Wall Barrier EN (optional accessory for all models) The Dual Mode Virtual Wall barrier keeps Roomba in the places you want to be cleaned — and out of the ones you don’t. In between cleaning cycles, you can leave the device operating in its position on the floor. You can set your device to one of two modes to fit your home’s cleaning needs: Note: Under normal use, batteries will last 8-10 months.
Regular Robot Care Recommended Robot Care To keep Roomba running at peak performance, perform the following care procedures. Instructional care videos can also be viewed in the iRobot HOME App. If you notice Roomba picking up less debris from your floor, then empty the bin, clean the filter and clean the extractors.
Emptying the Bin Cleaning The Filter 1 Press the bin release button and pull to Important: Empty the bin before cleaning the filter. remove the bin. EN 2 Pull the filter to remove. Tap the filter against the rubbish container to clear the debris. Reinstall the filter. Remove and clean any hair and debris from the Brushes and brush bearings. Flexible Brush Brush Bearings Main Brush Replace the filter every two months Cleaning the Brushes 2 Open bin door to empty bin.
Cleaning the Front Caster Wheel 1 Pull firmly on the front wheel to remove from the front caster assembly. 2 Remove any debris from inside the wheel cavity. 3 Spin the wheel by hand. If the rotation is restricted, remove the wheel from its housing and push firmly to remove the axle and clear any debris or hair wrapped around it. 4 Reinstall all parts when finished. Make sure the wheel clicks back into place.
Troubleshooting EN Roomba will tell you something is wrong with a two-tone distress sound followed by a spoken message. The troubleshooting indicator ( ) will also blink. More detailed support and videos, are available through the iRobot HOME App as well as online. If the problem is not resolved, visit www.irobot.com/Roomba600. Rebooting Instructions For some errors, rebooting Roomba may resolve the problem.
iRobot Customer Care USA & Canada Outside USA & Canada If you have questions or comments about your Roomba, please contact iRobot before contacting a retailer. You can also find additional information such as maintenance tips and information about accessories on the iRobot HOME App or on our website at www.irobot.com/Roomba600. Visit global.irobot.com to: • Learn more about iRobot in your country. • Get hints and tips to improve your Roomba’s performance. • Get answers to questions.
Regulatory Information EN This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device contains a licence-exempt transmitter/receiver that complies with Innovation, Science and Economic Development (ISED) Canada’s licence-exempt RSS(s).
