User Manual

ManualsBrandsiRobot ManualsCleaning Supplies & VacuumsiRobot Roomba 675 Wi-Fi Robot Vacuum

10 For more information, visit www.irobot.com/Roomba600

iRobot, Roomba, iAdapt, Home Base and Virtual Wall are registered trademarks of iRobot Corporation. AeroVac and Dirt Detect are trademarks of iRobot Corporation.

Regulatory Information

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

This device contains a licence-exempt transmitter/receiver that

complies with Innovation, Science and Economic Development (ISED)

Canada’s licence-exempt RSS(s). Operation is subject to the following

two conditions: 1) This device may not cause interference, and 2) this

device must accept any interference, including interference that may

cause undesired operation of the device.

• Changes or modiﬁcations not expressly approved by iRobot

Corporation could void the user’s authority to operate the equipment.

• This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference to radio communication will not occur

in a particular installation. If this equipment does cause harmful in-

terference to radio or television reception, which can be determined

by turning the equipment o and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

• Under Industry Canada regulations, this radio transmitter may only

operate using an antenna of a type and maximum (or lesser) gain

approved for the transmitter by Industry Canada. To reduce

potential radio interference to other users, the antenna type and

its gain should be so chosen that the equivalent isotropically

radiated power (e.i.r.p.) is not more than the necessary for

successful communication.

• FCC Radiation Exposure Statement: This product complies with

FCC §2.1091(b) for mobile device RF exposure limits, set forth for an

uncontrolled environment and is safe for the intended operation

as described in this manual. Per FCC requirements, maintain a

distance of more than 8 inches (20cm) between any person and the

host device (Roomba robot).

• ISED Radiation Exposure Statement: This product complies with the

Canadian Standard RSS-102 for portable RF exposure limits, set

forth for an uncontrolled environment and is safe for the intended

operation as described in this manual. Per ISED requirements, main-

tain a distance of more than 8 inches (20 cm) between any person

and the robot.

For battery recycling go to call2recycle.org;

or call 1-800-822-8837

WC:  v