Installation Guide

Models

A-46

A-42

E-342

NE-342

NE-242

Recessed Mounting Instructions

Tools Needed

Stud Finder (Optional)

Carpenter's Level

Tape Measure

Utility Knife

Phillips Screwdriver

Small Flat Head Screwdriver

1/4" Nut Driver (Optional)

Drill (Electric Recommended)

1/8" Drill Bit

1/4" Drill Bit (Surface Mount)

Safety Glasses

Electrical Instructions

Installation Instructions

Surface Mounting Instructions

and wall coverings and trim have been applied.

Rough-In Kit available for use prior to drywall being installed.

Great for new construction or open wall reconstruction when remodeling.

Rough-In Kit simplifies installation at a later date when room completed

PAGE 1
Installation Instructions Models A-46 A-42 E-342 NE-342 NE-242 Recessed Mounting Instructions Surface Mounting Instructions Electrical Instructions Tools Needed Stud Finder (Optional) Carpenter's Level Tape Measure Utility Knife Phillips Screwdriver Small Flat Head Screwdriver 1/4" Nut Driver (Optional) Drill (Electric Recommended) 1/8" Drill Bit 1/4" Drill Bit (Surface Mount) Safety Glasses Rough-In Kit available for use prior to drywall being installed.
PAGE 2
Recessed Mounting NE-242 Models Not Available for Recessed Mounting 1. Determine desired ironing board height using the chart below. Care should be taken to ensure the unit will be mounted at the desired ironing board height.
PAGE 3
Surface Mounting When surface mounting recessed units, it is recommended a trim kit be installed. 1. Determine desired ironing board height using the chart below. Care should be taken to ensure the unit will be mounted at the desired ironing board height.
PAGE 4
ELECTRICAL INSTRUCTIONS ALL ELECTRICAL WORK MUST BE DONE IN ACCORDANCE WITH ALL APPLICABLE ELECTRICAL CODES. WARNING: TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING OR SERVICING THIS PRODUCT. Note: Opening in the top of the ironing center cabinet for the electrical supply wire is located 2 1/4" on center from left side of cabinet and 2 1/4" on center from the back of the cabinet. 1. Remove the two screws from the electrical wireway cover.