2020 Installation Instructions

STEP ONE: Determine Mounting Height
46” Boards: 11”
Ex: Desired Height 35” - 11” = 24” Mounting Height
42” Boards: 7”
Ex: Desired Height 35” - 7” = 28” Mounting Height
IAW-42: 7”
Ironing Board
Height
Mounting
Height
Identify your desired ironing board height (typical ironing board is
33”-35” high). Then subtract the number below based on the length of
your model’s ironing board to determine mounting height (FIG 2.1).
STEP TWO: Locate Stud & Pre-Drill Holes
Locate and mark stud on wall. Cut two 2” x 4” braces to the desired
mounting height to use for bracing the unit during installation.
Using a 3/16” drill bit, pre-drill hole into center of the top cleat of
cabinet.
With 2“ x 4” braces in place for support (FIG 2.2), place unit on wall,
centering with desired stud.
Mark the location for mounting by placing the drill bit through the
pre-drilled hole in cabinet. Dimple the wall by lightly pushing the drill
bit into the dry wall. Set unit aside, then adjust location if not centered
on stud, and pre-drill hole in wall for mounting.
FIGURE 2.1
FIGURE 2.2
STEP THREE: Install Unit On Wall
Partially insert one #14 x 4” screw into the pre-drilled cabinet hole.
Then, using 2” x 4” braces, place unit back on the wall (FIG 2.2) and fully
insert screw through cabinet cleat and into stud. Remove braces. Plum
and level unit.
Using 3/16” drill bit, pre-drill hole through the center of the bottom
cleat of cabinet into stud. Insert remaining #14 x 4” screw through cleat
into stud to fully anchor the unit.
STEP FOUR: Apply Trim
Apply trim [not provided] to sides of cabinet to flush the side wall with
the cabinet trim (FIG 2.3) to create a sleek look (excludes IAW-42).
FIGURE 2.3
INSTALLATION COMPLETE!
Note: May use custom trim or purchase Surface Mount Trim from us
directly. Please call 1-800-536-9495 for more information.
Ex: Desired Height 35” - 7” = 28” Mounting Height
NON-SWIVEL IRONING CENTER | PG. 6
MODELS E46 & E42:
PLEASE REFER TO ELECTRICAL INSTRUCTION ON PG. 7 BEFORE PROCEEDING.
SURFACE MOUNT INSTALLATION
NON-SWIVEL
Models | E46, NE46, E42, NE42, IAW42