Installation Manual

PRE-INSTALLATION
Please follow these Pre-Installation steps to ensure your ironing board will
work properly in the installation location you have selected.
STEP ONE: Ironing Board Clearance
Begin by ensuring your desired installation location has adequate space for
your selected model. Choose Recessed Mount or Surface Mount.
Distance from wall
to tip of ironing
board
Distance from wall to
tip of ironing board
Clearance on both sides of
cabinet for board to swivel
1
2
Recessed
Mount
Surface
Mount
Recessed
Mount
Surface
Mount
SWIVEL MODELS | FIG 1.1
NON-SWIVEL MODELS | FIG 1.2
AE-46
ANE-46
AE-42
ANE-42 UD-42
E-46
NE-46
E-42
NE-42 IAW-42
” ” ”
 /” ” ”
” ”
” ” ”
” ”  /”
STEP TWO: Standing Room & Door Clearances
STEP THREE: Determine Mounting Height
STEP FOUR: Prepare Installation Location
It is recommended to have 16” on hinge side for the door to open flush against
the wall and move out of the way of the board. This is a requirement for swivel
models so that the board has clearance to turn. For comfortable standing
room to iron, we recommend 24” clearance on the desired ironing side.
Identify your desired ironing board height (typical ironing board is 35” to 36”
high). Then subtract the number below based on the length of your model’s
ironing board to determine mounting height (FIG 1.3). For adjustable swivel
models, take into consideration the adjusted position of your ironing board,
which is 4” higher than the normal, default position.
Aer identifying your installation location, use a stud finder to locate
necessary studs. Locate existing wiring or utilities to prevent drilling into or
severing wires.
46” Boards: 11”
EX: Desired Height 35” - 11” = 24”
Mounting Height
42” Boards: 7”
EX: Desired Height 35” - 7” = 28”
Mounting Height
UD-42: 16”
EX: Desired Height 30” - 16” = 14”
Mounting Height
IAW-42: 7”
EX: Desired Height 35” - 7” = 28”
Mounting Height
FIG. 1.1
FIG. 1.2
FIG. 1.3
PRE-INSTALLATION | PG. 2