Installation Guide

15
2. INSTALL ELECTRICAL WIRING
Position of Electrical Knockout
for RECESSED UNIT
2
1/2”
2
1/4”
1
1/4
”
DIA. VENT
HOLE FOR
WIREWAY
DOOR
CABINET
EXTERIOR
Position of Electrical Knockout
for SURFACE MOUNT ONLY
24
1/2
”
2
13/16
”
1. REMOVE ELECTRICAL KNOCKOUT
Open the front cover of the raceway
by removing the screw at the top
and bottom of the raceway.
Locate the electrical knockout, as
specied on diagrams provided.
Install a 3/8” romex connector where
the knockout was removed.
Ensure that power is
disconnected at service
entrance before proceeding.
Verify that there is ample supply wire
available to run from the top of the
ironing center to the approximate
location of electrical pigtails.
Note: A free wire length of 48” is
recommended.
Begin to place the ironing center into
its location while feeding the supply
wire through electrical knockout, and
the 3/8” romex connector through the
back of the raceway.
Refer back to installation
instructions before completing
steps on next page.
Electrical Installation - 17