Installation Guide

SWIVEL: SURFACE MOUNT INSTALLATION
MODELS AE46 & AE42:
Refer to electrical instructions on
pg. 17 before proceeding to next step.
MODELS ANE46 & ANE42:
Proceed to next step.
DO NOT attempt to install your own
electrical to unit. Warranty is voided if
independent electrical is installed.
2. PRE-DRILL PILOT HOLES
Using a 1/4” drill bit, pre-drill holes in
the upper and lower cross braces
inside the cabinet as determined in
previous step. Ensure that the holes in
both braces are drilled to the same
measurement.
1. PREPARE CABINET
Screws will be drilled through the upper
and lower cross braces (see illustration
on pg.3) inside the cabinet. Do not
attempt to drill into hard board of
cabinet. Determine location of screws,
ensuring that the location of the
mounting screw is as close to the center
of the cabinet as possible.
5. INSTALL UNIT
Begin installation by carefully lifting
unit into position. Then, attach the
cabinet to the wall by fully inserting
the screw in the upper cross brace
into the wall stud.
Make sure the unit is plumb and
level. Shim if necessary. Fully tighten
installation screw.
8 - Swivel Installation
Example shown
with studs & unit to
illustrate mounting.
Partially insert a #14 x 4” screw
in the upper cross brace.
4. PARTIALLY INSERT SCREW
3. LOCATE & MARK STUD
Using a stud nder, locate stud in
wall and mark the wall according
to the pre-drilled holes in cabinet.
Setting cabinet aside, pre-drill holes
in wall using a 1/4” drill bit.
6. INSERT SECOND SCREW
Insert the second #14 x 4” screw into
the pre-drilled hole in the bottom
brace of the cabinet and attach to
wall making sure cabinet remains
square and level.
FOR MODELS AE46 & AE42:
Please refer back to electrical
instructions to complete the
electrical part of your installation.