Installation Guide

ManualsBrandsIRON-A-WAY ManualsIroningUniversal Design Electric Ironing Center

TOOLS NEEDED

Stud Finder (Optional 1/4" Nut Driver (Optional)

Carpenter's Level 1/8" Drill Bit

Tape Measure Safety Glasses

Utility Knife Small Flat Head Screwdriver

Drill (Electric Recommended)

1/4" drill bit (Surface Mount)

PARTS SUPPLIED

Look for the small plastic bag attached to the bottom bar of the

ironing board. This bag contains the supplied parts.

Non-Swivel Models

Recessed Installation / four - #10 x 1 1/2" wood screws

E-46,NE-46, E-42,

Surface Mounting / two - #14 x 4" wood screws

NE-42, IAW-42 (IAW-42 only / two - #14 x 2 1/2" wood screws)

Swivel Models

Recessed Installation / two - #10 x 1 1/2" wood screws for

AE-46, AE-42, ANE-46, top portion of cabinet

ANE-42, UD-42 two - #14 x 2 1/2" Phillips screws for top side brackets

Surface Mounting / two - #14 x 4" wood screws

ROUGH-IN KIT

Rough-In Kit available for use prior to drywall being installed. Great

for new construction or open wall reconstruction when remodeling.

Rough-In Kit simplifies installation at a later date when room

completed and wall coverings and trim have been applied.

INSTALLATION INSTRUCTIONS

Assemble the required tools and parts before starting the installation. Read and

follow the instructions provided using the tools listed.

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Assemble the required tools and parts before starting the installation. Read and follow the instructions provided using the tools listed. TOOLS NEEDED Stud Finder (Optional 1/4" Nut Driver (Optional) Carpenter's Level 1/8" Drill Bit Tape Measure Safety Glasses Utility Knife Small Flat Head Screwdriver Drill (Electric Recommended) 1/4" drill bit (Surface Mount) PARTS SUPPLIED Look for the small plastic bag attached to the bottom bar of the ironing board.
PAGE 2
RECESSED MOUNTING You must verify the default position of the ironing board before installing the ironing center. Refer to the Ironing Board Height Chart below for the proper height of the various installation configurations. Make sure you use the correct model when selecting your board height.
PAGE 3
SURFACE MOUNTING You must verify the default position of the ironing board before installing the ironing center. Refer to the Ironing Board Height Chart below for the proper height of the various installation configurations. Make sure you use the correct model when selecting your board height. It is recommended a surface mount kit be installed when surface mounting recessed units.
PAGE 4
ELECTRICAL INSTRUCTIONS WARNING: TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING OR SERVICING THIS PRODUCT. All electrical work must be done in accordance with all applicable electrical codes. NOTE: Opening in the top of the ironing center cabinet electrical supply wire is located 2 1/4" on center from left side for the of cabinet and 2 1/4" on center from the back of the cabinet on all electrical models excepts UD-42.