Specification
Specifications
February 2015
Product Model Numbers
Ironing Centers: UD-42
Dimensions (Actual Size)
Overall height: 60 5/8”
Overall width: 15”
Overall depth including door: 7 3/4”
Dimension from wall to outer
edge of door (when recessed): 3 7/8”
Penetration into opening: 3 7/8”
Wall opening height: 59 7/8”
Wall opening width: 14 3/8”
Wall opening depth: 3 7/8”
Opening dimensions listed above
Overlap distances when using wall
Top overlap: 3/8”
Bottom overlap: 3/8”
Right side overlap: 3/8”
Left side overlap: 3/8”
Additional Information
• Unit may be surface mounted (unit extends
approximately 7 3/4” into room) or recessed
(unit extends approximately 3 7/8” into room)
into any wall with standard 16” center studs.
• See table bottom right to determine desired
ironing board height above the floor. The
user can adjust height of board after
installation with a 4” differential between a
maximum and minimum height.
• Unit can be provided with a left hinged door
upon request.
Right hinge is standard.
• Comes standard with wood veneer door.
• Electrical requirements: 115/120v, 15 amp.
Pigtails are provided in bottom of wire
raceway for hookup to supply line. Make
entrance into knockout provided in top of
wire way through right-hand vent hole.
• Recommended to attach 2” x 4” cleats to
studs, level with the bottom of opening (for
support when recessing unit.)
• Door opens approximately 180°. Allow at
least 16”
to the side of the unit for door to
swing open (door hinges on full length piano
hinge.)
• Options include: Surface mount trim
(necessary for surface mounting), oak, maple,
pine, or white raised panel door, flat white
door, glass mirrored door, or no door,
sleeveboard, rough-in kit, and iron.
See Page 2 for additional information
Board automatically engages to low position each time
the board is lowered for use. High position requires
adjustment and engages back to low position each time
the board is put away.
Height Adjustments
Cut Opening Minimum Maximum
(Default) (Adjusted)
Above floor Position Position
16” 32” 36”
15” 31” 35”
14” 30” 34”
13” 29” 33”
12” 28” 32”
11” 27” 31”
Specifications | February 2015