Manual

10
How To Remove Day Optic Sight:
1. Utilizing the ½” socket and the Seekonk torque wrench loosen the front
and rear mounting ring nuts but do not remove the nut from the cross bolt.
2. Rotate the day optic sight w/ rings towards the left.
3. Remove day optic sight.
Loading and Unloading
To Load The Rifle
:
1. Point the rifle in a safe direction.
2. Lift the bolt handle and pull the bolt handle all the way back, do not
remove the bolt completely.
3. Engage the safety.
4. Load five (5) rounds, one at a time, into the magazine with slight rearward
pressure, this will allow smoother feeding.
5. Hand feed one round into the chamber.
6. Use your finger to push the rounds in the magazine as far down as
possible.
7. Slowly slide the bolt forward so that the bolt slides over the top of the
rounds in the magazine.
8. Close the bolt ensuring the safety is engaged.
To Unload The Rifle:
1. Point the rifle in a safe direction.
2. Engage the safety.
3. Lift the bolt handle with one hand.
4. Hold the other hand over the ejection port.
5. Slide the bolt towards the rear.
6. Remove the extracted round from the bolt face.
7. Hold your hand under the floorplate.
WARNING: Make sure there are no cartridges in the chamber or magazine.