Manual
12
5. Remove the UNS mount by removing the (6) T-15 screws.
6. Open the floorplate
7. Remove front and rear T-30 trigger guard bolts.
8. Remove trigger guard from the stock.
9. Lift stock assembly straight up from barreled action (Only wiggle the stock
to break the suction). Wiggling the stock too much may chip the edges of
the bedding.
10. Assemble in reverse order using the Seekonk torque wrench on the trigger
guard bolts.
Storage and Transportation
1. When preparing the rifle for storage in the hard case, ensure that the
weapon is UNLOADED. Visually and physically inspect the chamber!
2. Leave the bolt body in the rifle at all times during storage.
3. Release firing pin tension by “Dry Firing” the rifle. (MAKE SURE THE
RIFLE IS UNLOADED AND POINTED IN A SAFE DIRECTION BEFORE
PERFORMING THE DRY FIRE!)
4. The safety will not be engaged, as the firing pin will not be cocked.
5. Always clean and lubricate the entire SWS before storage in the hard
case.
Cleaning the Rifle
1. Ensure the weapon is unloaded, visually and physically inspect the
chamber.
2. Remove the Suppressor and place to the side.
3. Remove Bolt Body and place to the side.
4. Insert Bore Guide into receiver.
5. Insert patch to the patch holder, on the cleaning rod.
6. Apply Bore Solvent to the patch.
7. Push the patch through the bore, all the way, pull back through.
8. Repeat steps 4-6 until 75% of the cleaning patch appears clean.
9. Leave bore wet with solvent while cleaning bolt body.
10. Remove Firing Pin assembly from bolt body using Kleinendorst bolt tool.
11. Wipe off any excess grease or oil from firing pin assembly and threads.
12. Blow off firing pin assembly with air, if available.
13. If air is not available use cleaning brush.
14. Wipe off bolt body, exterior, with cleaning patch soaked with solvent.
15. Drip solvent onto bolt face and clean aggressively with cleaning brush.
16. Blow off bolt body with air, if available.
17. Lightly lubricate firing pin assembly, concentrate on mainspring and
threads.
18. Re-install firing pin assembly into bolt body.
19. Lubricate bolt body with oil.
20. Apply grease to the back of both bolt lugs (On Bolt Body).