Manual

20
11. Re-install the turret cap by pushing downward and rotating clockwise (Never
Counter-Clockwise) until set to the number “9”, since that is 1 MOA below the
“Zero”. The number of clicks adjusted down in step “9” must match the number
below “0” you set the turret cap on. If you adjusted the brass screw 12 clicks (3
Minutes) set the turret cap on 7 and so on.
Problem: There is not enough depression to zero the rifle, the turret will not move
downward far enough.
Solution: Remove the turret cap, loosen the four screws and rotate the top cap
counter clockwise creating more clutch gap, continue by gently tightening
the four screws and replacing the turret cap (or) remove the turret cap and
zero the rifle by adjusting the elevation with a flat head screw driver in the
brass screw. Do not loosen the four screws for this method.
Problem: The elevation turret rotates too stiff, or easy, stiff, easy, stiff.
Solution: Remove the turret cap and release the tension on the 4 screws. Tighten
screws evenly and very gently, DO NOT TORQUE.