Manual

7
To Install the Bolt Assembly:
1. Point the rifle in a safe direction.
2. Put the safety in the “S” position.
3. Align the lugs on the bolt assembly with the receiver raceway.
4. Completely slide the bolt assembly into the receiver.
5. Close the bolt handle.
Fire Control / Trigger:
1. The trigger pull weight is set for consistency at 3.75 lb +/- .25 lb.
2. The trigger is set for combat reliability and should not be adjusted unless
broken or worn.
WARNING: Never remove the trigger mechanism or make adjustments to
the trigger assembly unless done so by a certified armorer.
Barrel
To Check Inside The Barrel:
1. Put the safety in the “S” position.
2. Remove the bolt body from receiver.
3. Remove any ammunition from the chamber and/or magazine.
4. Look through the inside of the barrel from the chamber end.
To Remove Dirt Or Foreign Object From Inside The Barrel:
1. Install the bore guide.
2. Push the cleaning rod w/ dry patch through the barrel, remove patch.
3. Install a clean patch and pull the new, dry patch back through the barrel.