MSDS

ManualsBrandsIron Out ManualsCleaning76 oz. Rust and Stain Remover

SAFETY DATA SHEET

1. Product and Company Identification

Product identifier Iron OUT (Powder)

Other means of identification

Not available

Recommended use

Rust & Stain Remover

Recommended restrictions

None known.

Manufacturer

Iron Out dba Summit Brands

7201 Engle Road

Fort Wayne, IN 46804-5875 US

Phone: 260-483-2519

Emergency Phone: 1-800-424-9300 (CHEMTREC)

2. Hazards Identification

Not classified.

Physical hazards

Category 1Serious eye damage/eye irritation

Health hazards

Category 1Sensitization, respiratory

Category 1Sensitization, skin

Category 3 respiratory tract irritationSpecific target organ toxicity, single exposure

Not classified.

Environmental hazards

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Causes serious eye damage. May cause an allergic skin reaction. May cause allergy or asthma

symptoms or breathing difficulties if inhaled. May cause respiratory irritation.

Precautionary statement

Prevention

Use only outdoors or in a well-ventilated area. Avoid breathing dust. In case of inadequate

ventilation wear respiratory protection. Wear eye/face protection. Wear protective gloves.

Contaminated work clothing must not be allowed out of the workplace.

Response

If on skin: Wash with plenty of water. If inhaled: Remove person to fresh air and keep comfortable

for breathing. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses,

if present and easy to do. Continue rinsing. Immediately call a poison center/doctor. Specific

treatment (see this label). If experiencing respiratory symptoms: Call a poison center/doctor. If

skin irritation or rash occurs: Get medical advice/attention. Wash contaminated clothing before

reuse.

Storage

Store in a well-ventilated place. Keep container tightly closed. Store locked up.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations.

Hazard(s) not otherwise

classified (HNOC)

None known.

Supplemental information

Not applicable.

3. Composition/Information on Ingredients

Mixture

CAS number %Chemical name Common name and synonyms

7775-14-6Sodium hydrosulfite

15 - 40

497-19-8Sodium carbonate

10 - 30

7681-57-4Sodium metabisulfite

10 - 30

77-92-9Citric Acid

1 - 5

7757-83-7Sodium sulfite

0.5 - 1.5

Composition comments

US GHS: The exact percentage (concentration) of composition has been withheld as a trade

secret in accordance with paragraph (i) of §1910.1200.

#7840 Issue date 16-March-2015

Page: 1 of 8

Summary of content (8 pages)

PAGE 1
SAFETY DATA SHEET 1. Product and Company Identification Product identifier Iron OUT (Powder) Other means of identification Not available Recommended use Rust & Stain Remover Recommended restrictions None known. Manufacturer Iron Out dba Summit Brands 7201 Engle Road Fort Wayne, IN 46804-5875 US Phone: 260-483-2519 Emergency Phone: 1-800-424-9300 (CHEMTREC) 2. Hazards Identification Physical hazards Not classified.
PAGE 2
4. First Aid Measures Ingestion Remove victim to fresh air and keep at rest in a position comfortable for breathing. Oxygen or artificial respiration if needed. Do not use mouth-to-mouth method if victim inhaled the substance. Induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. If experiencing respiratory symptoms: Call a POISON CENTER or doctor/physician.
PAGE 3
8. Exposure Controls/Personal Protection Occupational exposure limits US. ACGIH Threshold Limit Values Components Sodium metabisulfite (CAS 7681-57-4) Type Value TWA 5 mg/m3 US. NIOSH: Pocket Guide to Chemical Hazards Components Type Sodium metabisulfite (CAS 7681-57-4) Value TWA 5 mg/m3 Biological limit values No biological exposure limits noted for the ingredient(s). Appropriate engineering controls Good general ventilation (typically 10 air changes per hour) should be used.
PAGE 4
Auto-ignition temperature Not available. Decomposition temperature Not available. Viscosity Not available. 10. Stability and Reactivity Reactivity This product may react with strong acids. This product may react with oxidizing agents. Possibility of hazardous reactions No dangerous reaction known under conditions of normal use. Chemical stability Material is stable under normal conditions. Conditions to avoid Contact with incompatible materials. Incompatible materials Acids. Oxidizers.
PAGE 5
Components Species Test Results Sodium metabisulfite (CAS 7681-57-4) Acute Dermal LD50 Guinea pig 1000 mg/kg Rat 2000 mg/kg Inhalation LC50 Not available Oral LD50 Rat 1131 mg/kg Sheep 2515 mg/kg 2.5 g/kg Sodium sulfite (CAS 7757-83-7) Acute Dermal LD50 Not available Inhalation LC50 Rat > 5.5 mg/l/4h Oral LD50 Mouse 820 mg/kg Rat 3560 mg/kg Skin corrosion/irritation Prolonged skin contact may cause temporary irritation. Exposure minutes Not available.
PAGE 6
Name of Toxicologically Synergistic Products Not available. 12. Ecological Information Ecotoxicity The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment.
PAGE 7
15. Regulatory Information Canadian federal regulations This product has been classified in accordance with the hazard criteria of the Controlled Products Regulations and the SDS contains all the information required by the Controlled Products Regulations.
PAGE 8
Sodium sulfite (CAS 7757-83-7) US. Massachusetts RTK - Substance List Sodium hydrosulfite (CAS 7775-14-6) Sodium metabisulfite (CAS 7681-57-4) US. Pennsylvania RTK - Hazardous Substances Sodium hydrosulfite (CAS 7775-14-6) Sodium metabisulfite (CAS 7681-57-4) US. Rhode Island RTK Not regulated. Listed. Listed. Listed. Listed. Listed.