Installation Guide

ManualsBrandsIroncraft ManualsFence Panels(Actual: 5-ft x 6-ft) Chatham Bronze Powder-Coated Aluminum Decorative Metal Fence Panel

HAMMER

TAPE

MEASURER

MASONS

STRING

2” x 2”

WOOD

STAKES

SHOVEL

WHEEL

BARROW

DRILL

PHILLIPS

SCREWDRIVER

WOOD

BLOCKS

ADJUSTABLE

WRENCH

HANDHELD

SAW

POST HOLE

DIGGER

CONCRETE

Required Tools

STEP 1: PLAN YOUR DESIGN

Decide on your layout and remember to consider where the gate will be installed. Regular posts should

be set 72-1/2” apart, measuring from center to center of each post, while gate posts should be set 1“

wider than the width of the gate itself to allow room for the hinges.

Layout the perimeter of determined fencing area with stakes and masons string to keep posts in line

when installing. Place the wood stakes where you intend to install the posts.

All IronCra aluminum panels can be installed on an incline. The same method of installaon should be

followed, simply push the panel up or down to accommodate a hill or slope.

Post Post

72-1/2”

Center of Post

PLEASE NOTE: Addional accessories are required if installing on hard surface, such as a deck, or if mounng the

end panel to a wall.

TIP: All aluminum panels can be cut to

the size needed. When cung, use a

standard hand saw or reciprocang saw

and be sure to leave 2” of spacing at the

end of each horizontal rail.

RECIPROCATING

SAW

Aluminum Fence Installaon Instrucons

IronCra Customer Service

1-888-662-1788

Monday - Friday

8am - 5pm EST

Summary of content (3 pages)

PAGE 1
IronCraft Customer Service 1-888-662-1788 Monday - Friday 8am - 5pm EST Aluminum Fence Installation Instructions Required Tools HAMMER TAPE MEASURER MASONS STRING 2” x 2” WOOD STAKES SHOVEL POST HOLE DIGGER CONCRETE WHEEL BARROW DRILL PHILLIPS SCREWDRIVER WOOD BLOCKS ADJUSTABLE WRENCH HANDHELD SAW RECIPROCATING SAW PLEASE NOTE: Additional accessories are required if installing on hard surface, such as a deck, or if mounting the end panel to a wall.
PAGE 2
STEP 2: CHOOSE POSTS helpful to drop each post at the appropriate stake to avoid LINE POST CORNER POST END/GATE POST STEP 3: POST, GATE & PANEL INSTALLATION wood (to protect the post) hammer the post into the ground approximately 2” so the post is 24“ below ground Tip: Measure between 21” - 24” from the bottom of the post and mark with chalk or a temporary marker to ensure proper height placement. The mark on the post should align with ground level once post is in ground.
PAGE 3
Once the ﬁrst post is in the ground, pour concrete to ﬁll the hole, ﬁlling just enough to provide a slight slant for water runoﬀ. Assemble panels and posts by inserting the horizontal rails on the panels into the pre-cut holes on post. Secure the posts with screws included. Place 2” wood blocks underneath the panel when attaching the panel to the post for additional support.